Recent content by Shiltsy

We are getting ready to break ground... thought I’d check back and see if anyone has feedback or ideas that are better to plan for now than later. Thx!

Ok, figured out the pics!

As we work to finalize plans for our 28x34x11 outbuilding w/vauled ceiling, was hoping to get some feedback on the plans and point out any potential issues you guys see. The space will be used for: - storing a few motorcycles and wrenching on the classic one when it breaks down - snowmobile -...

About four years ago, I used craigslist (for the last time) to find someone to mud/tape and another person to paint our attached garage. Long story short, this gave me a first hand look into the world of a meth user. I went out to check on the painter a few hours into the project and found...

Kenwood - thanks so much! The G terminal on the back of the heater seemed to have constant 24v (tested with voltmeter) but when I ran that to C on the Nest, the furnace just constantly cycled on/off. The good news is that I just had the furnace installed last week, so I'm going to have the...

Cool, I have will have to check that out. As it turn out, I have bigger issues! There is no Common "C" wire in my two wire setup to the Reznor UDAP 45, so the furnace was cycling all night but won't run properly with Nest. Basically, I need to run another wire to provide 24V to the Nest C...

Good morning from tropical Minnesota, where we are expecting highs in the 40s today! I recently installed a Next thermostat in my garage to control 45k BTU Reznor. I liked the cool factor, but also the ability to control heat remotely, schedule, etc... From what I can tell, unless I put the...