Recent content by Shrimp92

This was my first every tile job, used the orange ditra for the waterproofing. Found a cheap cabinet, then got a granite top at Home Depot with sink for like 250. I’m proud of it. Wanted to see if I could do decent tile work in shop before I do the house. That’s an electric heater above the...

Shrimps Shop Album

Update Struggling getting Flickr photos to embed by using iPad…

Here’s a little update. A lot has been built, shop has cluttered. But i have gotten back on garage journal and it’s gave me a second wind to clean up the junk and get back to the “obsessed” way of life. I made an album on Flickr so i put a lot of photos in there. Built a couple of trucks for my...

Stage 2 to come...

Updated Pics: Tankless hot water Reverberray 55,000BTU heater found for 100$ Temp Heater till I get done with ceiling Sorry for the mess. Tile baseboard? Still pondering... Finally Crete Concrete guy had to order edging tool I wanted, I like it wide...

I have a 40x50 with 4 doors, 3 front. 1 back middle. I made middle doors 12x10 and other fronts 12x9. I wanted to access everything without mving everything. This is my shop. http://www.garagejournal.com/forum/showthread.php?t=190110

I ordered 4 liftmaster 3800s, seller said 3800s are getting replaced by 8500s. I said ok. I'm love technology so was excited to see that the my Q was part of the 8500 motors. Here's a picture of the app, I have 2 12x9 and 2 12x10, they have no trouble lifting the doors, although I did get a bad...

My dad's father passed away when he was two, therefore, the mold for his life was warranted by people around him. He worked for a mechanic shop when he was 16-18 to help his mother as they were barely making it. I guess that is why he is a borderline hoarder, he hates to throw anything away. He...

Thanks guys for the tips. I did pancake a few of those washers. I started with the lap side the worked my way to the fat lip. The screws are in the lowest spot of the metal. I hired the vinyl guys to put up the metal outside. Thanks for the comments about my shop. It's a job, but will be worth...

Yes, the screws have the rubber washers. I am out of town till Monday, but here is the picture I have. Notice between the screws about the middle of the sheet...

I have installed about 5 of the 42 sheets for my 2000sqft shop. The sheets are 17' long. I am using sheetrock lift with 2 1x6x16 laid across top for support. I have trusses 16" oc. I am installing metal roofing screws 32"oc. My problem is I am getting a dimple between the screws, dead center...

Well, I have stalled as long as I can...I can't decide on the ceiling for inside the shop. It's either drywall or the roofing metal (white) like you see in the pull-through area outside. They are about the same price...metal may be a bit more.What do you guys think? The reason I'm hesitant about...

I have to agree mark. I'm gonna get just strictly cabinets and the smaller wall cabinet, think the hf 44" is hard to beat for tools alone. The workbench looks solid though.

I am going to get some of the cabinets for my shop. I really like them for the money. I noticed on the Seville website, they have a mega cabinet now. It's big!