Recent content by Ska23

Thank you very much!

Also is the double pole breaker correct? The 10 in the previous paragraph is meant to for single phase

The picture isnt clear. The panel states: Maximum operating current : 13.7 Starting current: 9 MCA: 17 Maximum breaker: 20 10 208/230v 60hz I have the 20amp double pole breaker. Just want to make sure the wire is ok. The wire is already installed and dont want to waste money for additional...

Im currently having a mini split system installed and originally ran 10 gauge wire, red, black and green inside 1/2” pvc conduit from the panel to the disconnect but now decided to install a Fujitsu system instead which only requires a double pole 20 am breaker. Is this ok? I know it wont burn...

The installation manual states its good up to 80’

Anyone know where to purchase 14/4 TC-ER-JP over 50’? I need approximately 65’.

The drain is t the problem, that can go right through the side of the house down the siding and out. Ill hide it in line hide so it looks neat. My problem is routing the line set. The easiest path is right ip to the attic and meet right above the room where the sir handler is. Im just not sure...

What type of wire connectors did you use to connect the Honeywell (tray cable ) to the condenser and air handler.

Any advice for running the line set for the init on the opposite side of the house?it was the last question in the beginning of the thread.

I would prefer the ez in southwire but it goes from 50ft to 250ft. Nothing in between

The head to the outside unit. So it will have a couple of feet exposed from the line hide to the condenser.

Thanks for responding. Can the cable you recommended be installed in the line hide with out conduit?

Good morning All, Im currently installing a dual mini split system and have a few questions about the control wire installation. I been doing carpentry for many years but have limited knowledge with HVAC wiring. Ive seen most of the control cable tied to the line set inside the line hide but...

Im planning on installing a dual zone mini split system and would like to know the best way route for the the line set for the second zone which is on the opposite side of the house. Here are my thoughts for routing the line set: 1. From the condenser, through the attic, secure along the attic...