Recent content by skeeballhead

My brother gave me a roll of 8/3 with ground. I want to wire a sub panel in my garage for a Millermatic 210(30 amp input), a 220v 20 gallon air compressor(15 amp input tops) and a dedicated 20 amp 120 volt recept. Bought a 6 circuit main lug panel. Anyway, was gonna put a 60 amp breaker in...

I have a Rezloh(serrated) Edge from a TC40 tractor I had. The bucket that I got with my L180 doesn't have any holes so the holes will need to be precise. I will check with the local rental stores in Topeka to see if they have any. Might see if somebody close in the construction industry might...

Any suggestions on drilling 9 or 10 holes in a 72" skid steer bucket. Holes will need to be 5/8" diameter. I imagine the cutting edges on those are hardened steel???(Maybe) Anyway, any suggestions or am I making a big deal out of nothing, which I usually do. Just didn't want to spend all day...

It was for the System I, included delivery from Iowa(around Des Moines), installation, and the Mohawk weight guage that you install on the lift to tell you roughly how heavy a given vehicle is. The dealer was super nice, just a great guy. I was just trying to justify the additional $3100.00...

Should have read your post a little better. If you have an 11' requirement, the XPR-10CX probably won't work. Bendpak makes some others, but I don't think they are clear floor. Just go to their website. If that is the case, better make it a Mohawk.

Well, I looked around for two months before deciding on a Bendpak XPR-10CX. My friend bought one as well. Paid $2610 through MetroLifts on ebay. All went smooth as silk. They are priced as such through the end of December w/ free shipping. It is certified, and built extremely well. Looked...

old car guy, how do you like the bend pak lift compared to the system I?

I know you are only asking about the "General" and not many folks have replied, but if you are looking for a metal bldg, I bought one through www.premiersteel.org. All went well, and fit great. One thing about these metal building companies is that most are actually only metal building...

Yeah, I do like the footprint of the Mohawk, but man are they pricey. I poured concrete where the post will sit a bit thicker. It is probably about 2 feet deep x 4 foot wide and 11-12 foot across w/ rebar. Everyone seems to think their lift is better than the other, which is understandable...

Just got done building my 30x50x12 shop and want a 2 post lift. Any suggestions on brands. I have been looking at a lift made by WORTH in Texas, anybody have one. I would need a 10k capacity lift. Anyway, if anyone has any insight on this brand, let me know. I did contact their salesman, and he...

I put my question on general garage discussion.