Recent content by skippy_ps

Weird. Shows up in my post.

Just click on the pic in my post to expand it, then right click, choose Save imgage as... and save to your computer.

Got this one a few months ago. Fired it up, set regulator to 90 psi, hooked up 25' 3/8 hose and 1/2 impact. It would barely move a lug bolt at 90 ft lbs. Some head scratching but ended up getting a Husky "High Flow" regulator at HD and Milton V hose fittings on everything. Works fine...

toolsdelivered web site says that after 30 days, contact the manufacturer. I assume that means a phone call to Snap-on for what to do.

Williams MSSD-12RC, 1/2 drive, 12 point, deep metric set. USA.

Aircat 1150, Milton hi-flow fittings.

Aircat 1056-XL. Knocked those lug nuts right off, no problem.

Yep. I've ordered directly from them a few times and purchased from them through Amazon. Top 'net seller.

1/2" 250 ft lb Tekton. Checked it a couple of times against a digital torque adapter and it's within 2 - 3% at 100 ft lbs.

It's not slow like it takes 30 minutes to do anything but it is a little pokey reading the vin and then scanning. I usually get mine to the ready to scan position which takes maybe a minute, maybe less, then let it scan and go do something else. Come back a few minutes later and write down...

Bought a new set of SK 3/8 drive sockets earlier this year. All but one were coated on the inside. Curious, I dunked the 15mm in acetone and swished it around a little. Took the coating right off and underneath was a perfectly formed socket. On the left is a de-painted 15mm, then a painted...

I have the Schwaben version which is essentially the same as the Foxwell NT510. Mine has BMW, Mini and RR software. I got it to figure out an ac problem on my E60 and it figured out that the outside temp sensor was shot. So, it paid for itself on the first use. It will cycle all of the...