Recent content by smuro04

Went to Lowe’s today on my way home and was looking for that rubber rug runner for a tool box top, saw it mentioned in another thread. Couldn’t find any bit did happen to find a nice rubber mat, 3x4, with a tear on the edge. Got it for $9 out the door after a little haggling (normally $22 and...

See post 125. Also, HF sells Icon ratcheting wrenches without any type of anti slip design on the open end, same price.

My apologies, the Icon appear to be a long pattern whereas the Dewalt are a standard length. Icon’s are $150 for a 10 piece set and the Dewalt can be had for around $90 for a 12 piece set.

Icon is overpriced, period. The only icon tools I would consider are their ratchet wrenches and torque wrench, however... You can buy the SAME ratchet wrench sets from Dewalt for 2/3 the price. And you can buy a better quality torque wrench from CDI for roughly the same price or a little...

Had them, and sold them. While I really liked the electro plated finish on them vs the standard black oxide on almost every other manufacturer out there, I couldn’t get past the COO (China). Don’t get me wrong, the fit and finish on them were great, but I found the Sunex to be slightly cheaper...

Fixed that number for you. That’s what showed up when I searched Lowes.

I got the newer 1/4” socket set when it first came out; excellent quality/price ratio. Super happy with them. Just bought the 30pc Metric/SAE wrench set the other week after deciding I had enough of the sloppy QC on the Gearwrench 40something piece set and sold them off. Considered buying...

Top of my HF cart: HF socket trays with the center dividers cut out. No worries about skipped sizes now.

I’m using the HF trays which I think are the best bang for the buck. I scored the center dividers (the piece with the sizes printed on them) and snapped them off. Now all my sockets fit and I’m not worried about missing sizes or whatever.

Added another pegboard under the folding tray, a magnetic tool holder for my grease gun, and a magnetic tray that I took the magnets off and riveted to the bottom tray for my hand packer, CV grease, and some funnels. I used one of the magnets from the tray to secure the tip of the grease gun...

They do. I just used a 25% coupon to purchase the magnetic shelf today. Exclusions are always in the fine print of the coupon.

I put some of those magnetic tool holders to use... I riveted two in above each spray can holder. What I like about this is it keeps all the cans from rattling around and possibly spilling out when rolling the cart around. Especially nice for the upper holder as it keeps all the smaller...

Pegboard is installed... Also swapped out the crappy drawer liners for a nicer material I found at Lowe’s. Waiting on some tools to show up, then I can get a Prybar rack fabricated and I’ll probably to a little tool cart tour. Thanks to everyone in this thread for putting out some awesome...

So I was perusing Lowes today and stumbled upon this steel pegboard panel. Come to find out that if you rotate the side cross bar on the cart so that the lip is facing down instead of up, the panel fits in there like it was meant for it! There’s mounting tabs on sides of the panel that are...

I’ll let the picture speak for itself... It’s pretty much buttoned up. Just need to touch up some paint in a few spots, tighten down a few bolts, and figure out a way to secure the bottom drawer section. I’m really happy with it! I ended up trashing the spare cart idea, so I put all four...