Recent content by snakedoc257

Do they sell Snap-On tools at Costco?

NuttsGT, thanks, for the input, I've been checking out your garage it's awesome. I'm a fellow Fox Body Mustang owner too. I'm going to check with the county tomorrow. I am still undecided on what to do. I think re-arranging everything to put in dry-wall is going to be too much for me to...

NuttsGT, thanks for the advice. I've never messed around with a sprinkler system before. I've traced it all back to a shut off valve, but haven't investigated the system anymore than that. I'm not gonna mess with it until I find out how to do it right. With my estimates on how low the...

Yeah unfortunately he can/did. It passes in GA. because he installed a sprinkler system. I am trying to decide on how to finish it. I would like to drywall it, but with all the plumbing up there I'm afraid to. I'm thinking my best route is a drop ceiling. I hope to tackle it in couple of...

Good to know, I'll start looking. Tile would just be easier for my situation.

I am leaving mine bare concrete for now. I wanted Racedeck, but would rather spend the money on my Hot Rod right now. Then I decided to go Epoxy, but can't find the time to prep and there is no way I can empty my garage for 7 days. I was thinking of just doing a clear sealer. Legacy...

****, I new I should have researched building codes before buying this house. I would have had him drywall the ceiling. With the amount of ducts in my ceiling wouldn't the ceiling look like ****? I guess I could lower it and build a frame out of 2x4s like a drop ceiling? That 4" line is an...

I love this shelving idea. I have been drawing plans and thinking of different ways of vertical supports. I like the threaded rod idea best, but don't know how I would make it work with a drop ceiling. Any ideas? Here are a couple of pictures of my ceiling as it is now.

Yea, I guess I'll keep looking. It would be nice if it was that easy. I will have to say that if feels tougher than the Armstrong VCT tiles at Lowe's. It's more plyable and didn't crack like the VCT did when I bent it. However, it feels tougher on the top surface if that makes any sense. I'm...

I live in West Georgia, and there is living space above my garage. In the area I live in the garage must have a sprinkler system in it if there is living space above. I don't know why they used plastic pipe for the sprinklers, but it was the same in my old house too. I know it's not PVC pipe...

Sorry forgot to post the picture. Here it is.

I have a Snap-on box my dad gave me years ago, a Craftsmen top and bottom quiet glide set that I got 18 years ago as a graduation present and then two weekends ago I bought my first HF box. I had been looking for a tool cart for a while and was just about to buy the Craftsmen one for $399 until...

I am just starting on finishing my 20x28 two car garage and would like some input on flooring. We've been in our split foyer home for four years and I've decided to it's time to finish it. I do not remember if the builder sealed the floor in the garage or not. I know, I know I should have...

I'm new to the forum, and love it. I found it after someone on one of the Mustang forums suggested I look here before starting on my garage project. I am going to finally finish my small 20X28, two car garage in our split foyer home and I am looking for some suggestions. I am going to start...

New to the site and so far can't stop reading. I found this site on one of the Mustang forums I post on. I am looking for ideas on finishing my typical 500SQ. FT. two car garage. We've been in our split foyer house for 4 years and all I've done is load it up with two mustangs, extra parts...