Recent content by Snap-co

Sold

I have a Matco TRC150 torque wrench for sale. I'm selling because I don't hardly use it. It has never been abused.it is a 10ft-lbs to 150ft-lbs. I'm asking $175 shipped

I was in HF this past weekend and I asked the manager about the warranty and he said as long as it has Pittsburg on it they will warranty it.

Nc-Fordguy thanks for the tip. Can you post a picture up so I can do the same

Sorry need4racing I didn't see any but wasn't looking to hard either. I was tempted to get the 1 inch drive ratchet set it was $180 makes down to $40 but I was already at my limit.

I don't go to HF very often but I needed some gloves and they had a side walk sale going. Long story short I walked out with 3/4in impact gun for $10 and a slide hammer kit for $10 and a 1/2-3/8 combo ratchet for $2 and two pairs of gloves for $3 each.

Hello everyone I'm new here and so far have found some interesting conversations. I have always loved working on cars,trucks,tractors and pretty much anything that has a moving part. I learned most of what I know from my Grandpa. He always said you don't need a fancy truck tool to do the job...

Where did you pick up your foam at?