HF sale

[Snap-co]

I don't go to HF very often but I needed some gloves and they had a side walk sale going. Long story short I walked out with 3/4in impact gun for $10 and a slide hammer kit for $10 and a 1/2-3/8 combo ratchet for $2 and two pairs of gloves for $3 each.

 

[Need4racin]

were the blue nitrile 100 pack gloves cheaper than $6.99?

 

[NC-Fordguy]

I have that slide hammer kit. The three prong axle shaft thingy is cast. Broke the second pull I used it.

I welded it back together and then welded a piece of 3/16 plate to it. Works like a champ now.

Knowing what I know now, I would have welded the plate to it before I used it.

Something to consider

 

[billymade]

NC-Fordguy, if you could; would you take a pic of the repair? I'm sure our fellow members with the same kit; could use this as a way to upgrade theirs... thanks!

 

[onelochevy]

checked out the sidewalk sale here on saturday. only thing that caught my eye was a Pittsburgh floor fan that i would like to get for the garage. left without it though.

 

[thenephilm]

I got a 20 ton press for $130.00 and picked up a stud welder for $90.oo something.

 

[Snap-co]

Sorry need4racing I didn't see any but wasn't looking to hard either. I was tempted to get the 1 inch drive ratchet set it was $180 makes down to $40 but I was already at my limit.

 

[Snap-co]

Nc-Fordguy thanks for the tip. Can you post a picture up so I can do the same