Snip's's latest activity
-
SThey literally tell you the COO of EVERY SINGLE ITEM on their website. They also provide a link to all tools made in house and all tools...
-
SThey are. And you are correct - I would agree with you regarding the offsets. That said, if I were Tekton, I wouldn't be putting any of...
-
SMy father was a sheet metal guy at Ternstedt which later was bought by GM and the plant became part of Fisher Body. Not that it matters...
-
SAs I mentioned before, I have a toy — a 3D printer. It turns out to be a very useful thing in the garage. I've already printed a bunch...
-
SAfter digging in a bit yesterday, it does have a rubber layer on the upper wheel. Just grimy and a bit hard. Will work on that and see...
-
SSnip's replied to the thread What did you do "IN" your garage today?.Can't tell from your photo, but it looks like the upper wheel is missing the urethane bandsaw tire... That and there should be a tension...
-
SSnip's replied to the thread Sears Craftsman DP 113-21371.Workpiece clamp... Used to prevent the drill bit from grabbing the part and becoming a Craftsman Bass-O-Matic blender... Here's mine...
-
-
SSnip's replied to the thread Expensive Mistake.At quitting time at the shop after the guys left for home, I'd always walk back to the welding area and check the welding bottles...
-
SPackard Craftsman Motor 115.7556 - Part 4, Cleaning the Stator Cover Band This stator cover band has some light to moderate rust...
-
SSnip's reacted to zimman's post in the thread Where Can I Get These Electrical Connectors? with
Like.
Not if you're good at what you do. I've never had a failure in all the 150mph cars I've wired. Zim -
SSnip's replied to the thread What did you do "IN" your garage today?.I replaced all my shop faucets with T&S Brass, sourced from McMaster-Carr... Still running drip free for over 25 years now...
-
SSnip's reacted to Beerhippie's post in the thread What did you do "IN" your garage today? with Like.
T&S Brass "Eterna" line. I've replaced damned near every faucet in the brewery and pub with them. Easy to source, inexpensive parts--and...
-
SHad a buddy come by and lend a hand got the mill and lathe off the floor. They are being rehomed. Probably fab a couple 4x4s to go under...
-
SDP#152 - Part 15, Installing the Head Frame Assembly It's time to install the head frame onto the column. I started by degreasing the...
