Recent content by Soundchasr

I'm not sure it's the color coat because after he finished the color coat and put down the chips it looked incredible. It was only after he put on the clear and AO that it went bad. If he adds another color coat to it won't it be uneven because of the chips? Or do you mean he should sand...

Yes, and I can still see the roller lines.

I posted previously about a problem with a recently installed epoxy floor with aluminum oxide. After the job was done I could see lots of roller lines all over the floor. Further, parts of the floor glossy and other parts were not. It was "patchy". So, the guy agreed to come back and put down...

Do you think another coat of clear will fix it? The guy is planning to come out this week and said that should help...

It's the roller lines of the clear coat. I saw it before the clear coat went on and it looked awesome.

Just got my new floor done. Looked great after the epoxy was put down. However, after the clear coat was applied with aluminum oxide, I could see all the roller lines and it looked really uneven in areas. It's been dry for about 2 days. I assume this is because of the AO? Here's a pic...

I searched around my area but couldn't find a shot blast. I found a hand orbital with vacuum at HD that I'll probably rent. Do I need to worry about getting paint and joint compound off first if I'm using the grinder? Any additional prep after grinding? I'm thinking about epoxy-coat but...

What did you use on your orbital?

It's 21.5 x 21.3. So, about 450 feet. It looks like it's sealed to me too. I'll check for sure tomorrow.

Anybody? Any suggestions on the type of contractor to call if I don't do it myself?

Hi all: I'm planning on putting down an epoxy floor in my garage. The house is about 15 years old. You can see in the pictures the condition of the floor. It's mostly covered in joint compound and dust right now. :o I can't tell if it's ever been sealed. I want to make sure I do the prep...