Recent content by spcv

Boy, do I deserve a facepalm. Better yet, a slap! I was afraid to go full throttle on the impact driver. Once I upped the Nm, the chuck came out! Thanks for the patience, guys! And all the good advices! I’ll bother you again when I get the new chuck!

Well, that didn’t work. Both strategies, with a wrench and a hex key. I used my strength, then a hammer, then a Stanley sledge hammer, then the strength from the drill and finally I used an impact screwdriver while locking the spindle with the open wrench and holding the drill on a vise. It...

Ok, guys, finally found a supplier with a LLambrich CPM-13 R-1/2 on stock. I'll get it next week. Now the problem seems to remove the Rohm from the Hilti. I looked inside the chuck and there is no screw inside. Should I use wrenches on the spindle and "mouth" of the chuck? The spindle is...

Thanks for replying, KnurledNut. I don't even know if there's a word for carbide in portuguese... I'm guessing both Rohm and Llambrich have them, since they are such reputable brands... So far none of the online sellers has responded to my request for information on prices and...

Wow, that was some very nice response! Thanks again, neophyte. The drill was bought used, but works like a charm. Store bought Hiltis are so expensive that adding a new chuck would still be a lot less than buying a new one. But now I'm divided. Rohm is a refference, but I thought that maybe...

Thanks for the reply, neophyte. I'm from Portugal, so my options are a bit more limited. Actually. the chuck on my drill is like this one: It's not in such a bad shape, but sometimes the bits don't hold very well, so I figured maybe I should change the chuck...

Hello, everyone. Long time reader, first time posting. I've searched (maybe poorly) but I couldn't find an answear to this doubt I have. Does anyone know if this chuck: is compatible with this hand drill? Sorry if it seems a dumb question, but I'd like to know before taking the risk of...