Recent content by spectralen

So would I be looking for a kit for a Walker 93632 or 93633? And what about the small grooves? I saw a guy use epoxy to fill them? Any thoughts? I just don't want this leaking. There is a small seal where the tank came away from the block. It may have been silicone?

Would you know if I can purchase the seals in the pictures by them selves and with a tank seal? Thanks

Just the one side shown is like that. It doesn't rub the ground at all since I've owned it, so a repair was done years ago. I was just going to replace the cup seal and the 3 other seals shown, and if there is a tank seal.

When you say leather, Is it a rubber over leather? The discs are rubber but almost look like they have a fraying of leather. I was just going to flush with a transmission fluid and call the block area good and not take it all the way down, seeing it worked fine.

Tried polishing a little.:confused: Do these seals look factory?

Update: The ram appears to have some scratches and pits. I took some pics and hope they might be helpful if someone can tell me if this ram is junk. I have access to a lathe if that's an option to remove the imperfections and order a slightly over sized seal? I just don't know if that's...

I have about 6. When I see them in garage sales and can pick them up at 5 to 7 bucks, no brainer. They are awsome.:thumbup:

That's what I was thinking it was too, just want to get the right parts. This thing works great but leaks. As I was taking apart, I saw welding where the block meets the frame. So I grinded the weld to take apart and I can see that the tapped hole is very low and coming out the bottom of the...

One step up from a pancake. Way too much $$$. Belt drive is the only way to go.:thumbup:

Starting to rebuild. Would be great if someone knew what this was. Thanks