Recent content by squirrel17

My furnace called for X6670 Lennox filters (16x25x5) and i got tired of the prices and through some research I found recommendations to use cheapest filters you could find so the blower doesn't have to work as hard. So what i did was got the cheap (16x25x1) filter for approx 4$ and made a 2x4...

in. thanks.

Found this, looks similar minus your castings numbers and different base. Could be same program just different years.

Ah good to know. Thanks!

I throw my blades in PVC pipe with 2 end caps

Picked this up for $100 although I didn't need another vise. Took spindle and jaws off and it's got a coat of BLO. Missing its' base but I'm sourcing one for it. Date on keyway is 180 Curious though, what is the sticker supposed to look like? Wilton 500, but the part in the black at the top...

Beginner welder suggestion from me would be the Lincoln 140 MIG from Home Depot. That is what I run, and I've done patch panels on a squarebody (bedsides,cab corners, rockers), I've repaired a 6x12 utility trailer with broken welds, I've patched a mower deck with rusted holes, and others that...

I got my fancy swivel impacts that i wont ever use do to this exact reason.

OK sounds like a plan, I'll run it to make sure it works and change out the oil and use stabil/rec fuel. No need for oil in cylinder . Thanks again.

I purchased a gasoline generator this summer for an eventual extended power outage, but thankfully we didn't need to use it. I did put the supplied oil in it, but have not started it. My question, is it good to store as-is? never ran Or should i treat this like anything else and put some...

Just a friendly heads up, but i had a 1/4 hex to 1/2 drive adapter that had broken, i reached out to [email protected] and they processed a warranty claim. 5 days later , and ups gives me a package. They sent me a bulk pack (qty 25) I know its a 4$ piece and most wouldnt bother but this time...

To my surprise they say USA on them

Quick response, didn't have to send them in, just pay shipping to get a new pair. Even though they ask me to dispose of the originals, I'm going to keep them and just cut the tips even.

Bought a bunch of SK right before they announced they were selling out. First time these pliers even touched metal the tip snapped right off. Submitted the warranty claim to see their response. Expectations are set low.

Snap on badges came in from ebay fast.