Recent content by Steve in Mi

I have a couple of questions; Do you plan to have a condensate drain on the bottom of the tank? And, When was the last hydrostatic test done on the tank? Looks like a nice clean installation. Servicing it could be tricky but ladders and scaffolding will help.

Took my camera and headed out to the shop, didn't find the exact type I have used in the past. I had a few but suspect they got used up for air foot peddles like you're looking for. I did find a couple of alternates for you. First is this 11706 valve, fairly common to sand blast cabinets for...

Are you saying that after all the work you put into this charger (and it is very pretty, nice job), it will not be functional? Why not?

Yes and yes. These are the numbers I posted. Furnace model # is SRM - 54608 A (this is a downdraft furnace) LP 2 stage gas valve Model# VR 850 A 1011

Why not ask Saylor Beall; Address: 400 N Kibbee St, St Johns, MI 48879 Phone: (989) 224-2371

Why not ask Saylor Beall; Address: 400 N Kibbee St, St Johns, MI 48879 Phone: (989) 224-2371

Not an upgrade but an important maintenance item to ensure long life. Get a few spare intake filters for the compressor and change regularly - dirt in the pump will not be good for the long haul.

When I bought T1-11 for my shop build in 1981 it was available in Pine and Cedar, Cedar being considerable more money. You may want to check what material options are available today for T1-11.

A hydro-static test is the best method I know of to insure a tank's integrity/ability to withstand working pressure plus a margin of safety.

"possibly for SCUBA tanks" my thought on it also. The pressure setting on the pressure relief valve should give a clue if it will pump in the 2,000 psi neighborhood necessary for dive tanks. Still need good oil and water scavenger units to clean up output before breathing it.

You are right, lots of good info. Welcome to the Garage Journal Board!

Look again, that's a LP hose not a power cord. See how it ends at the tank! Only electric heaters I see in the room are used for lighting.

If he is truly a Buick Boy = Flint, Mi. (Buick City) What does your salamander make heat from? Electricity, fuel oil, LP or ??? Cost to purchase? Cost to operate? LP puts out a lot of water from the combustion process - do you need or want more water in the garage?

These tanks don't last forever. Leakage occurs when they rust either from the inside out or outside in. If the tank is no longer needed it is best to do whatever is required to remove the tank before a spill. And that is just my opinion.

Yes, but it will probably take 2 or more to take the chill off. Tractor Supply sells 1500 watt heaters for approximately $20., even less when on sale. RedStone Multi-Purpose Fan-Forced Ceramic Heater with Thermostat and Fan $19.99