Steve_P's latest activity
-
SSteve_P replied to the thread Drilling Stainless - Where did I go wrong.Slow is nonsense. If you try to drill a 1/4" hole in 304 SST at 80 RPM you will get nowhere. But try. You need good bits. Stainless...
-
SSteve_P replied to the thread Show your new tool arrivals.Wilde. They make them for lots of manufacturers, including Proto. I am not a huge Wilde fan, but these pliers are legit. I am not...
-
SMarketplace KRL1201 top chest to complete my stack and facilitate my tool addiction!
-
SI’ve used them on hundreds of brass fittings and the damage inflicted is greatly overstated, IMO. MAYBE you get two lines imprinted on...
-
SSteve_P replied to the thread Knipex 5 piece double edge broken bolt extractor set vs traditional EZ Outs?.Project Farm did an extractor test FWIW.
-
SSteve_P replied to the thread Show your new tool arrivals.Their lock ring pliers, typically used for rebuilding a manual transmission are fantastic. Otherwise I have no other pliers by Wilde...
-
SKlein Tools D532-7 pliers wrench with knurled jaws. Made in South Korea. The 10" model is supposed to deliver to me on Tuesday. I can...
-
SThis weeks gets:
-
SJust picked up a M18 Mid-Torque 1/2” impact. Home Depot had a deal - buy the tool and get a “free” 5.0 battery FWIW, Gator magnets...
-
SSpent some money this week. Grabbed the fixed extensions off a Matco BOGO promo on the last flyer. They were on backorder for about...
-
S“F”ridgid cooler
-
SHad one of those days where multiple eBay packages arrived, and I incidentally found a Snap On truck in the wild. Overspent at SO on...
-
SSteve_P replied to the thread Torq screw drivers and wrenches for electrical work?.Cant go wrong with Wiha for any type of driver but you'll also get ten other opinions, as always.
-
SSteve_P replied to the thread Offset Extension Wrench.You can change the rear plugs in a Roo with a low profile ratchet like a Gearwrench 90T, Tekton 90T, Matco 88...... Put the socket on...
-
SStahlwille 14 Series Long Combination Wrench Spanner 13mm
