Recent content by stratman1

Does anyone have a manual for a Snap-on MT-335 coil-condenser tester?

I had a 2 post for 10 years and loved it. I moved, tried to have another 2 posts installed, but they couldn't due to the concrete, so I went with a 4-post. I hate it. Difficult to work on suspension, brakes etc. , plus I am always dodging that extra metal from my head. I have also used my 2...

I just moved to Florida. I got an oil change and they told me not to get out of my car. One guy got down into the pit while another guy at the same time handled the paperwork. Before I got my credit card out, the job was done!

Can these saws be fitted with a metal cutting blade? I am looking at one to purchase, but the seller doesn't know about the product.

I bought my 9koh from GS about 4 years ago and love it. The only thing I did was to move the motor from the end of the post to the side of the post to give me more room to walk around it.

Well I bet that salesman does not sell Atlas. That's why Bendpak is his #1 seller. Show me a better 2 post overhead lift for $1,595!

I bought the 9KOH from GS a little over a year ago and I could not be happier with the lift. I had it delivered and installed for $600.

I should have provided more info. The tank is in the basement and in very good condition, its about 15 years old. The weep is from the very first fitting that comes out of the bottom of the tank. I did try to tighten it. The next pipe is a 4 inch pipe that has a shut off valve on it that...

Does anyone know what to use? I dried the fitting and then tried Permatex 2 but that didn't work. I can not remove the pipe on the bottom of the tank to put sealant, if I do the tank will drain. I have a oil tank goes to my oil furnace. It is just weeping a very little bit, stains the...

Does anyone know where to find run capacitors for a discontinued HF Central Pneumatic 90234 air compressor? I called HF and they said they no longer have parts for that model. I also tried Grainger.

Please provide a photo.

Your work and attention to detail is awesome. Curious. What is wrong with the dusters and wiping it down with towels, because this is what I do with my car.

I just spotted a Harbor Freight gun on sale for $9.99. With my 20% coupon it will be $7.99 #67187 20oz, Gravity Gun. What do you think of this? Will it do the job? Required air pressure: 50-70 PSI Air consumption: 6 CFM Output: 200-300cc per minute Nozzle size: 1.5mm Cup capacity: 20 oz

I will be spraying a door post, speedometer console and some odds and ends. The console will have clear on it. What chepo spray gun do you recommend to do both paint and clear. Also what other items will I need to get started to do it right. Enclosed are the specs of my Harbor Freight...