Recent content by Sub Dude

I am looking for a complete arbor assembly for a Delta 34-400 10” Table Saw. This would include the carrier assembly, the arbor shaft/spacer/lock nut and bearing retaining ring (threaded). Also, the blade nut and washer. The part number may be 422-03-014-0011. It rotates on a ¾” shaft. Other...

Looking for these two items. I'm restoring this saw and these parts are missing on one hand wheel. I'm trying to keep this all original and peer not to use aftermarket parts. If you have the entire hand wheel shoot me a price. The handle is around 2" long with a 1/4"+ shaft. Thanks, Sub Dude

Your are correct 450mA vs 200mA. I read it off my meter and it was set to 2 decimal points. Sub

Done and Done. I just converted two fixtures and things went well. I may have purchased a 3500K vs 4K but I think the bulbs I bought will work well. I just measured the amp draw on the fixtures. My old fixtures draw 45mA and the LED fixtures 20mA. I appreciate the help folks! Sub Dude

I found a Halco bulb that looks good: Bulb Its available and I think I'll try that one. Sub

Thanks all, I think I'll get these ordered and give it a shot. Appreciate your help. I'll let you know how things go. Just went back to order and HD is out of stock. I'm looking.... Sub

So, Get some double ended bulbs and wire Hot to one end and Neutral to the other and that's it? I got these bulbs in my cart: Bulbs I don't see that they are listed as double ended though.

Thanks. I guess it would have helped if you could see what I am looking at. This is the connector from the odd fixture. ITs tombstones are a different design than the others. I'm gonna take this info and read further about the items you mentioned.. Thanks

I have a shop that is around 16 by 20 feet with 10 ft ceilings. I have 7-4ft two bulb hooded florescent fixtures. I purchased a box of bulbs 10 years ago when we built the house. I’ve used all of the bulbs and now I think I had a ballast go bad so I’m down one fixture and I’ve got other bulbs...

I just picked this up today and can't seem to find out much about the model. It says Series 34-770 and the SN is 1791. I am familiar with the Delta Serial numbers and can't figure this one out. The model (or series) 34-770 is hard to find online. I did find a manual that is about the same as...

And that's why I bolted it down to work on it.

Thanks. My nature these things are a little tippy. I don't feel compelled to change the belt at this point. The one I have on it seems OK. Sub

I just finished a "respectful" rebuild on this early 1940's Cman 12" bench top Drill press. I pretty much tore it apart and found that the quill bearings were shot. Replaced those and now its smooth. It came with a bit in the chuck but no key. After getting the proper key and getting the bit out...

Well it didn't last long. I put it online a few days ago with a price that I thought would only appeal to someone who new what this machine was. I got a note that someone wanted to "look at it". I have only had one time in the last 40-50 tools where someone came to look at a machine and then...

Glad you enjoyed it!