SurferRosa's latest activity

http://vintagemachinery.org/photoindex/detail.aspx?id=45567

It might be very faint. I say stamped, but it is just ink. Sometimes I can only make out a partial...

That number is interesting... I have a few of those Block Bench Grinders, but none of them have a number like that on the label. You...

Hi All, Just an Update: I got my new pulley installed, and with the set-screw aligned with the rear spindle dimple, and the Thrust...

I think I found one. Part number is not quite right L2-3A (should be L2-3B), but it seems correct. A little more than I wanted to...

That is a good point. The indexing pin does have some travel to it, but unfortunately my indexing pulley was sheared off at the large...

Hi Ronnie Appreciate your insight and photos. There are a number of people that have those bearings exactly where you have them...

Agreed, "Pulley Side" written on both sides sounds like some kind of Machinists inside joke... Yes, Thrust & Shoulder Collars are...

Frank, I might have seen that VM post before, and it is part of the reason for this thread. It looks like the restorer of that lathe...

Hi Frank Here’s a few images of the Bearing OD is 1.4”, and it is .42” thick. I thought about replacing, but these are difficult to...

Hey Tom, Thanks for this. I was thinking of punching some brass flat stock, but rod will be easier and I can get it a little thicker...

Hello All, This is my first post here, but I have been poaching great ideas from this Forum for years. I am recently retired and have...