Recent content by swampymarsh

Sold....

For Sale Hossfeld # 2 bender For sale is a used basic Hossfeld # 2 Bender. Includes main frame, swing arm and swing arm extension. Can break down to make shipping easier but the ride is on your dime. $350.00 OBO email me at [email protected] if interested Thanks!! Dave

OK, I needed to send my Quill assy to have the spindle taper reground on my Bridgeport Series I mill. Not always have the best of luck with UPS, Fed ex or the like, I build (over-engineered) a shipping crate that would get there and back hopefully protecting my investment. The story ends on a...

Hum....wonder why my pic did not post? Lets try it again!!!

Needed a back hoe for some around the home projects and I'm too lazy to use a shovel. Also built a front end loader (not shown on these pic) for it because it also required shovel work to fill back in the hole that I dug.

Bump!! Any takers? Hate to scrap.......

Bump!! still for sale.

Used Johnson gas/propane melting/heat treating furnace, Model #120. Good shape, comes with blower, gas mixing valves and stand. Located in Cincinnati OH. Great price at $200.00 Dave (859)468-6783

Selling my 15 inch Pioneer vertical disc sander. Use on either metal or wood, New Baldor 120/220 volt,1750 rpm, single phase motor, heavy cast iron and brass construction. Work table tilts -15 0 +55 degrees, geared tilt and table has height adjustment. Weighs in at around 250/300 lbs...

O-Engineer. Nope- they only had the set of three. Everything else was way too big. May want to keep and eye out on ebay. Evogun. Love the XT. Had it now for 5-6 years with no problems. I I opted for the stich timmer as well which is good for sheet metal(though my tig leaves a stronger...

Lilredex No CRV for me. I put them in the back of my Tundra. Pull them out of Burlington Canada. Nice area, a lot of wine there. :D

Thanks for the nice comments!! These plates were used for a vertical set-up on a milling machine. The great thing about these are that they are only 2 inches thick and made of cold rolled steel then the t-slots were machined in(read...easier to move LOL!). A milling machine table (or similar)...

As you know, things shift while you are welding so I wanted an easy way to lock down the fab parts. After a lot of searching I finally found my t slot plate that I was looking for. But unfortunally to get the width I was looking for I had to buy three 11" x 60" x 2" plates and build the...

Do a search on phase converters on the www. You should be able to find resources on how to build static phase converters and save you some cash. Dave

These are used an anchor point for pulling frames, etc. Just an extra pulling point if you need to do some heavy work. You used to see these alot in body shops until the advent of the modular frame jigs. Dave