Recent content by tbirkey214

Lol. I want to get it running. I have to make a tensioner, but I dont have the piece or really know what it looks like. I found a video of another guy that has one but chit hides behind the top wheel. If your in Dallas I am always buying and selling tools if your looking. AND I sponsor a tool...

I I added the rod sticking out because that peice nmdidnt come with the machine...it was in parts. I would think that maybe you would turn something but there are no gears. I really need a manual or someone else with this machine to shoot me a pic

Ok, yes yall were right, I switched the ground and line and the motor is working fine. Something told me to give a good squint and wear leather gloves when turning it on before... would hownit was wired up electrify the metal of the machine??? Did i mess anything up by turning it on to test it...

Im half retarded, let me go back and see, that's why I get the feeling maybe the wires are crossed up because the motor tries to move but it's like it doesn't have enough power to actually do anything

Okay I will take a better look at that, and remember I am really not good at electrical stuff. So when I get back home I'll look and see if the ground wire is going to one of the power legs instead. Yes once I get this working I will switch everything over to more legit and safety things but I'm...

The Dual is a model's 26, and it's about 6 in taller than my garage and about 1500 lb. I've been able to tip my Powermatic but the model 26 is just two massive I thought I was going to die when I was getting it off my trailer. Plus I rent so I don't know how long I'm going to be here even though...

The pulley on the motor spins freely, and all I can tell you about my three phase converter is that it is from American rotary so it is a real three phase power supply. The problem that I try to show in the picture is that the motor pulley starts to move but it just kind of Wiggles back and...

I bought this piece of **** at an auction sight unseen cuz I wanted a band saw, and it was just in pieces and I was literally just going to drive it to the dump but I changed my mind and I'm going to try to diddle with it because I'm too bitter that I can't get my nice do all bandsaw into my...

Thanks!!!

No. They're part of the casting, kind of hard to explain, but one side is flush and the other side is not so you can't even flip it around

Minus the non reversible blades. That blows

Nice reply

Excellent reply. Much thanks

Okay so I took both of the blades off and while one does feel kind of sharp the other one does feel a little dull and rounded. I'm extremely Tapped Out on cash right now, so I'm going to have to wait a little bit but I'll send these out to somebody to surface grind

All right so I found a couple other PEX to a manuals and it doesn't really say anything about setting to 5 to 10% Like The I guess common trades knowledge says to. It does say that you should be able to cut a heavy piece of paper all the way across it, now I don't know what heavy piece of paper...