Recent content by tc-cad

Can you share what the square foot cost to build Home Only is in AZ? I live in Wisconsin we have basements so that does ad to the cost. I was told I could build simple not fancy home for around $220/square foot. To me that just seems like a lot?

Get some one to laser cut out a Blank for a Bomber Seat that should make it very easy to build.

I can't wait to see your work. I have thought about doing the same thing. All I need is a bead roller..............................

Yes I am.

I have a garage floor that has seen 27 years of neglect. This summer (if it ever comes) I was going to rent a concrete polisher from Home Depot and then I was thinking about just waxing the concrete. Has any one else done this? Thanks TC-CAD Freezing in Wisconsin......................

JSK Do you have the Hydraulic Diagram for this lift? Can you share?

Looking for Hydraulic Diagram for Scissor Lift with Two Cylinders on each pad.

Greta looking Garage and nice lift set-up.

Get a Scissor lift the it can be flush in the floor NO posts. Thats what I did.

That is a Section View of the Die Design.

Pink is the Punch. Gray is the Pressure ring must be bolted through the blank into the punch (to prevent wrinkles) then push Punch through the Green Die. Simulation shows it should take 15 tons of force to force punch through the Die.

Looks like you will need 15 tons of force on the punch to form this perimeter at 90 degrees.

What mkind of printer did you get? What is biggest size you can print?

Can there be holes on the inside? You need to hold pressure ring to punch so it does not wrinkle.

Oh I get it you are forming a flange around the circumference.