Recent content by tc_rain

I am wanting to install an air conditioner in my garage and believe I would need one that that would require 220v. I do have a 220 outlet in the garage on the opposite side wall that is a 50 amp outlet used for my welder. I was wondering if I could make an extension cord to plug into the...

It is natural gas and I am running the double wall vent pipe so I will just have to write it up as condensation. Too bad it is right above my workbench. Especially since I am a woodworker and will have to make sure I don't leave any projects on it. Thanks for the input.

I installed a Mr. Heater in my garage. It is suspended from the ceiling above my workbench. For the last several weeks I noticed a small puddle of water every now and then on the workbench directly below the heater. As I looked into where it was coming from, I noticed it seems to be coming...

Thanks for all the help. The vent goes up last since I am going to have a professional come out and cut a hole in my roof. I just can’t bring myself to do it. I am sure I could but just too apprehensive it might leak sometime in the future. I will also have him look over the rest of the...

Vent pipe is next after electrical. I think I am going to move up to 12/2 too.

I am installing a Mr. Heater MHU 50. I have the gas and thermostat ran. I am now about to run the electrical to a dedicated circuit using 14/2 wire to a 15 amp breaker. The run is no more than 12’. Anyone see a problem with what I have so far? This is my first time at doing something like...