Recent content by Teter09

Yes, the new hose will replace the copper pipe. So I need a male inverted flare connection to screw in to the check valve. The adapter you linked to is what I have found also, but is the female side. The check valve was connected to the copper pipe by the steel nut which is shown in the...

But mine is 5/8 OD, and the threads are 7/8-18...

Correct, but it won't have much heat left after flowing through my aftercooler, which is why I'm looking to change the connection. Compression huh? The specs say its 13/16-18..which is slightly smaller than the 7/8 of the current nut. Is that to be expected/ok? Wait, where you thinking I was...

Hey Everyone, I have spent most of the last 2 days searching online and in stores for a fitting that I can't seem to find. I'm not sure what to call it or if it exists...hopefully someone here can help me. The Check valve on my IR compressor is connected to the pump by hard copper pipe. 5/8...

I bought the Cobalt 115 piece set because of how varied my use is....figured that set would make life easier, and I was right! Its been awesome having the correct bit size for every project no matter what. I love the cobalt since I drill steel quite often and they have been fantastic. Now I...

I wasn't sure if I should add to this thread or start my own, but here is the end result, EBMpabst Axial fan turning at 2200CFM, AKG Aftercooler in a cheap Steel Electrical enclosure I found (and Painted). I'm still getting the fittings to connect it in, but I'm having issues with one...

Vegas? I am IN!

Thanks Chuckcrj....your advice got me most of the way there. I got a bit of 'go' at first, but it didn't stay on. So I swapped the blue and brown...and away we went! So in the end it was, Green/yellow to the ground. Black to one leg of 240 Blue to one side of capacitor Brown and other side of...

Unfortunately there is no diagram on the fan tag. Here is the tag.

Ok, I think I need some more help because I've obviously made a mistake somewhere. Fan: EbmPapst Model W2E300-CP02-37. 230V 60Hz 4 Wire..... Green/Yellow Black Blue Brown The capacitor you all helped me pick out has arrived...

Original? I think you misunderstood that I read the capacitor needed from the fan tag, there is no capacitor at this point. It was new old stock at a place here in Orlando and was marked down to 5 bucks, so I thought it would make a good after cooler fan since it really moves the air! First...

Hey all! I'm building an after cooler for my compressor and went out to the garage to start today, and decided I should check that my fan did in fact work. When I hooked it up, it didn't work but on a whim I gave it a spin and low and behold, it started up just fine. I know this means I need...

So glad you extended this offer! I'm hoping I can adapt the plans to a smaller size so I can replace my POS harbor freight cabinet!

I'm not certain actually. I've read different ones, some say B&S #7, others #9, others have said the LB Collets and I think some say a cheaper option is the B&S #00. It came with a few Double Z collets that seem to work just fine. The e-tank removed most of the paint along with the rust. Any...

I didn't really take any pictures of the table. Not sure why, I think I just dove in and pictures were an after thought. It had an old Brown and Sharpe Vise with no jaws on it, which I threw in my electrolysis tank after being de-greased. The table was absolutely overloaded with grease...