Recent content by Texas eye

There's probably a lot of Truth to to that.

I went down to the inspectors Department this morning when they open. The slab passed inspection and there was nothing to help me in the code book for the Deep Honeycombs. They did question right away where the anchor points were with the J bolts. He says some contractors do that afterwards and...

I am going to call the inspector tomorrow. Do they check before the building starts? I will bring the issues I have up. Also asked to meet with the concrete boss to see what the plan is to fix the problems.

So did inspection with garage builder today and slab is also 1/2 inch off square. The slab is level. The honeycombimg is bad along the outside, it doesn't look like they used a ******** at all. If the slab guys go around and fill the Honeycombs will that be structurally sound? Is the patching...

I'm not sure if the used rebar for the curb. I have the garage Builder coming by today to take a look at it. I think it looks a little worse in person then it comes off in the pictures.

Brand new slab they poured this week. It looks like they poured the outer edge afterwards. I know it was all done the same day. But I'm not sure how they did it

It dark or would take a few more pics. I would say the poor section that worries me is the 3 inch footing. Is footing covered when garage is built on top? I'm concerned about it cracking right away once they start driving nails into it.

Pic of full slab.

I don't know much about concrete, but this seems to have more rocks than concrete in the mix. LOT of air pockets.