Recent content by TextileWolf

I easily could have just misunderstood. Thanks!

I really like the sand idea. Thanks. Just to make sure I was clear...this joint is between the floor and wall, not two flat surfaces. A self leveling product is ok in this scenario?

I installed my epoxy floor last fall and love it. I need to put some caulk of some kind at the wall and the floor. I have seen the SikaFlex self leveling product mentioned but I am concerned that would be too runny to be used in this scenario. The gap is about 1/8th of an inch with small...

I went with 4 on my last house and really liked it. I went with 5 on my current home because it has bricks on the garage wall.

I just did my floor and pulled up the tape after each application. It looked great. However I didn't tape the wall...as I am going to caulk.

I got the floor down this weekend and it is great. I could have spread the flakes a little more even, but extremely happy. I hope I got the clear spread correctly. I tried to be methodical, but really hard to see what the coverage is like. Now that the garage floor is so nice, time to...

Understood. The concrete wanted to dry during the middle of me pressure washing. I am going to try the moisture test in a couple more spots tonight. Assuming those are good...no reason I can't proceed is there? It will probably be Friday before I start...which would be 3 days.

I got the floor pressure washed yesterday and used fans to dry it out and it passed the moisture test last night. I am going to give it another day and start the process of the epoxy tomorrow night. The weather has turned warmer and a perfect weekend to tackle it. I can use tonight to do a...

I definitely think the dust wasn't helping matters. I think it was also not knowing what to look for. I found this online... My floor is performing like the second part of the video and not sitting on it like the first. Thanks for the help guys!

I have and the water seems to want to sit on top, compared to the whiter areas. I don't feel like I know exactly what to look for. It is hard to tell because it is still really dusty, but the darker area appears to also have a smoother surface profile. This is comparing the two areas...

So after cleaning up I am a little disappointed with what 5-6 hours of the Diamabrush did. I don't think it removed all of the sealer as what stays on top in some of the darker areas. It was hard to tell how it did before I cleaned all the dust. The angle grinder preformed well at the edge...

You are right. The diamabrush didn't really touch it. However, I was already going to use one for the edges, and it worked perfectly. I decided to use the diamabrush for the bulk of it and most of it look pretty good, but there are spots that I am not quite sure got the profile I wanted. I...

I have just completed one good pass with the dimabrush and was pleased with the results. Need to clean a bit to see if it will be the only pass. However, I noticed at the edge of the garage there is a few spots that are kinda rough. Any advice as to how I should treat it, if at all...

Thanks everyone. Hope everyone enjoys the weekend. I'll be spending mine grinding my floor.

Well I certainly don't intend to rush the prep as I know that is the most important part. Just wanted to see about an alternative route. If I did pressure wash, but is the typical time I need to wait before the primer goes down? Thanks!