Recent content by Tinkerer2

So are these backward compatible? What did the "tab" do? And about time for a Bosch deals thread.

Count me in. Thanks!

Regarding labels, I haven't had any issues with these: Ultimate Chrome Socket Label Set

I found an insulation company and it sounds like they are going to it right. Baffles for the soffits. They are going to blow insulation in under the flooring. The floored space is about 8X17 and you can get on each side of the 17 ft length to blow in insulation. Only obstructions are some...

Never thought about doing that. Is there an easy way to properly plug those holes? And do you have any idea how much would get packed in there when the machine bogs down? Idea on R factor?

The attic space over my garage is about 1000 sf. About 200 sf is floored with chip board. I'd like to keep that part floored. There are ceiling lights, electrical boxes and wiring under the floor. All floor joists are 2X6. I want an R-factor of at least R-38 for the non-floored area and was...

Thanks. I now have several choices to choose from.

Looking for a flashlight. Specifications 1. about 4 inches long 2. uses 3 AAA batteries in a cylinder holder 3. Has a lanyard. 4. Brightest possible I know that other specs would be better but I really need one this size. Don't want rechargeable batteries for this one. Any suggestions?

Got one!! Thanks

The wheel isn't on the ground. It's just touching. When you raise your bench the mechanism lowers the wheel and locks it below the bench foot. Raise it again and it releases it so it doesn't have the bench pressure on it. Check the video here: (scroll down on page)) How they work

Since I will be able to lift each end of the workbench, I'm going to give these a try. Four of the Original R7 Smart Casters

Sadly no. It's going in a closet and sharing space :). It will be closest to the door kinda in the middle (left to right) of the closet.

What is the distance from the table leg to the end of the orange lifting handle? And how tall is it from the top of the mounting bracket to the bottom of the table leg?

Great idea but doesn't seem to fit a 24" x 30" bench. Max width is 20 1/4 when building a rectangle.

Thanks. I saw the Holkie ones. I'm too old to get down on my knees and move the levers. I also looked at a video of them installed and the pads are "springy" - not solid/sturdy. The pin skate won't work with the area I have around the bench.