Recent content by tinmann83

We used to buy all our powder from spraylat. They were bought out by ppg. Thier poly and epoxies are good quality. www.patriotmetalworx.com if you have any ?s

Anyone know of a floor coating for concrete that will stand up to welding and cutting slag?

If you still looking send me a picture of what you need. Ill send if I can help you out cheaper than 60 bucks.

I haven't been able to locate such a plate yet. We may have to manufacture one.

I know for the audi AWD transaxles you have to blank off the back part of the ****** with a blank off plate that will hold the rear of the shaft. Just wondering if something like that would be need for the subaru.

The trans and motor are both from the subaru. No adapter plate needed.

The engine and transaxle haven't been delivered yet. When it does we will modify the engine support and rear hoop.

Good looking table!

The miller mig 110 model works pretty well as long as you run gas on it instead of fluxcore. If your going to be doing a little more serious welding I would look for a Miller 251.

Obviously its just the motor and transaxle going into the sandrail...lol. We were going to put a hayabusa motor into it, but the owner changed his mind.

Does anyone have any knowledge about putting a subaru AWD in a rear wheel sandrail?