Recent content by tn_popo

I've had this for a few weeks and still haven't gotten it organized properly. I work too dang much.

Can anyone recommend a source for individual sockets? I have a few sets both SAE & Metric and I would like to add a few additional sizes to each.

Thanks ssdave

So 6"-12" of sand as a base?

How would one prepare the site for Interlock Stone? And are the "concrete pavers" at Lowes the same thing?

When anyone enters my narrow driveway they usually cut the corner short and drive on the grass causing a muddy rut when it rains. I plan on digging out the corner and forming it to extend the corner of the driveway. Can anyone help me with the best products to use for a DIY project? I have some...

I'm getting tons of ideas from this forum, keep it up guys and gals.

80mirada what part of Tennessee are you in? I'm in E. Tennessee near Knoxville.

4x4 legs, 2x4 frame, 2 layers of 3/4" plywood tops all assembled with deck screws. Connected to the studs with 3'' screws and it's solid as a rock.

Thanks

Once a concrete floor cracks how long should I wait before repairing the cracks? How long til it has cracked all it's going to?

I've been learning quite a bit from GJ since finding it but haven't been posting. It's time to post some of the things I've been working on. A couple weeks ago I built a couple work benches.

I recently upgraded an old ceiling fan in my new to me house. I decided instead of tossing the old fan I would repurpose it to the detached garage/workshop since it still works and it's cheaper than buying a new fan. But before the install I figured a makeover was in order as the antique brass...

So once the cracks start does anyone recommend doing anything to fill or seal the cracks? My newly poured garage floor has some hairline cracks and 1 that's bigger.

I just purchased the house a few months ago, it was built in 1940 but I'm not sure how old the garage is. The breaker box is as it was when I moved in.