Recent content by tool-nut

I would agree with mostly 30's sockets and box and some into the 40-50's like the chromed 3/4 extension pieces. The ratchet is probably the 5/8 drive with adapters for 1/2 and the later 3/4 drive. And yes those "double square" were just like 12 points today and appear to be late 30-40's style...

I think this has been brought up before, but I can't find any threads for it. What is this tapered wrench for? http://www.ebay.com/itm/Snap-on-3-4-7-8-Open-End-Wrench-S2428W-Tapered-Ends-/330774105293#ht_3057wt_754 Is it only an obstruction wrench or is there a more specific function?

It is a Ford connecting rod socket. I believe it was for the Model A.

^^^^^^^^^^^ yep Sears wont replace it or supply rebuild kits. Worse yet, nobody runs a hydraulic rebuild service around here anymore. The last one I knew of shut down last year.

The Bausch & Lomb Safety goggles are here. Great condition and well packed. Thanks Roy!

PM on the b&l goggles.

Awesome offer, thanks for the chance.

Its under quick links in the black toolbar drop down

I might be interested if cudajunction is only looking for 3/4. PM sent

There was a thread about this a while back where a Gearwrench member discusses it. http://www.garagejournal.com/forum/showthread.php?t=19237

PM sent for partial lot

Just got it yesterday, I think it took a little detour somewhere over the holidays. Looks good on arrival, need to set it up and try it all out. Thanks James!

Got my set of channelocks today, fast shipping and well packaged. Thanks again.

Ok, I'll jump. PM incoming.

Do the single/double flaring kits make quality single flares or is it best to stick with two sets? I'm always suspicion when a kit claims it can do everything, but I have not tried it myself.