Recent content by Tool Time

we had a ground hog issue and tried many of the items noted. But the one option that worked best for us was to unwrap double bubble gum and threw 10, 12 pieces into the opening. It worked remarkably well Best of luck

Cutco, They are normally sold by door to door salesperson's; one of our friends was trying to make extra money during her college break. She stopped over to make her sales pitch and before she could even start I was bleeding on the kitchen table. Not the sharpest knife I ever owned, but...

Hi all I found these on Craigslist, they are located in Pa if anyone is in the market for one or two of the 13 drawer rolling tool cabinets. http://harrisburg.craigslist.org/tls/2763950034.html

It just worked for me, (flex heads) but the $29.00 didn't show up until I added the items to the cart?

Re: Flexhead Deal Still On! If you have the link for the flex heads please post it I can't find it listed on Sears webpage

In the last 8 years we have yet been able to clog our Toto. I wish I could say that for our other non-Toto's.

Connection Failure I am a bit disappointed today; I purchased a Maxjax during the last group buy in April and I have used my MJ a few times to change the oil rotate the tires, small things. I was planning on putting it to the first real test today. I have a bearing going bad in my rear...

Christine, Within the next few weeks I want to epoxy my garage floor but my Lowes does not carry your produce. I went as far to give them the item numbers but they as other Lowes were not able to locate epoxy coat by name. I have 920sqft I need to cover and that the present time it is likely...

I am glad I didn’t get the epoxy first this was a little more work than I anticipated. I have a ½” hammer drill and I bought a cheap 7/8” bit that lasted the first 2” before I rented a good drill and bit. I think I will be adding another set of holes and purchasing the epoxy style for that set...

I had vacation scheduled for this week; my plan was to epoxy the garage floor first then install the lift. But, I have not been able to get with Christine to walk my Lowes through ordering the epoxy coat. It probably was good I did the installation first the weather has been too hot in...

That was my outside measurement

I just completed installing my maxjax today and I struggled with getting the correct spacing for my vehicles. I have been reading the different posts and some of the spacing sizes others are using. I would like to suggest we create a post dedicated what spacing is working for our vehicles so...

Mine rolled in this morning; I requested a delay in shipping due to travel. I had the lift gate delivery and for those in question I didn’t have to touch anything the driver rolled it into my garage. For me this was worth the extra cost for the door to door service. I am in the process of...

Good point if I need too I will use a large pry bar and two pieces of pipe and roll it off the gate. They have the harder job by getting it on the gate which tells me they will have a pallet jack or something to move the pallet.

Good question, I do have a few dollies’ I would hope they would bring a pallet jack? If they don't, I guess I best have a few friends over and the grill going at the correct time or its going to be a long day.