Recent content by TrxR

Thats kind of my plan. I just got a PMA neck turner.

3 phase isnt an option here. Would thise work on a single phase?

How much hp does the gear reduction box require? I found one at princess auto that is a 10:1

What kind of costs are gear reducing boxes that would get me down to where i need? Its not a lathe exactly its just a motor that spins the brass while i run a hand held neck turner on it. Alot of people just use a cordless 1/2" drill but i would prefer something more stationary.

Whats out there for easy to find low rpm electric motors? I got a couple around here that are 1725 and 1350 but am looking for something around 540 to 6 something . Im looking for something to turn necks on rifle brass. I need to have a final rpm of around 170 to 200 RPM. I figured something...

Preferably no ignition source as I will have a fair amount of powder around.

Ive got a 2 story garage that is 28x36 that is insulated. Anyways I am going to partition off a small room about 9x12 upstairs and plan on insulating it as well. It is going to be used as a ammo reloading room. Anyways I was wondering what you all thought would be the most economic way to keep...