Recent content by turbotank

go into camera settings. and select 640x480. then your pics will be forum sized. nice cart btw

looks like when concrete freezes around here. is it brittle? like can u take a screw driver and chip away at it easy?

ur gonna need some supplies. get some yeungling, a couple friends, radio going, and some woofle ball bats. stand at garage drink beer, and swing away as they come in. fun time

i like the helmet. i also consider auto darking helmets for rookies. coming from years in the iron worker field, and now in high end high performance auto parts, i know what a good helmet is. i like the look of this helmet. now how are you gonna gurantee the uv protection? carbon parts are gel...

bump........

all brand new never opend the packages. these were my spares but i went ahead and bought 88tooth setups. 1/4", 3/8", 1/2" 50.00 shipped to lower 48.

and of course blade tooth count.for light duty sheet metal u might get away with a 14t but 18t would be smoother

blade speed. metal needs 50-100

wire edm?.

think thats sweet, laser is even nicer

ok i also found sure flow

i made a home made tig torch cooler about a year ago and it has been working fine except it goes through pumps. ive put in 3 used fuel pumps so far. i know fuel pumps are not rated for water/coolant i know but my intentions was to get it going and see how it worked and when i ran out of pumps...

with the handle tight or loose?

i actually love the matco screwdrivers. alot better than snappys imo. plus when u break one u get a whole new one. not just hammering off the handle. the phillips are awsome they are the only ones ive seen take out some of thottle body screws without stripping them.

columbus here