Recent content by twentythreemx

Was using the stuff from TSC.. grabbed a bag of fine and the medium.. Anyhow, I'm up and running. I don't know what the magic trick was, I didn't change anything in my setup, but I pulled the gun out and blew it out from every angle.. and same w/ the pickup tube. there's not much gap for air...

im convinced its my gun or pickup tube, i get like no suction.. i got a new gun that will be here tomorrow. i tried loosening the cap and making sure the tip was loose and free and i got a little out of it for a few seconds. can anyone confirm how the tube from HF should be hooked up? its a...

I didn't see a CFM rating on the filters but PSI was way higher than what I required.. I'll have to double check again. Combined rating for cfm between the 2 compressors is right where I need to be (I think it was like 9.9 off the top of my head?) Tried 2 different medias, one medium one...

Hello - I bought a HF blast cabinet without doing much research and didn't realize the importance of CFM with air tools until now, whoops. Keep in mind it's a new unit, maybe something withe gun is bad? But it wont siphon up any media. I'm convinced it's my compressor.. Its only a 35 galllon...

sounds like the good move is to just use the solvent and cross your fingers that you got a decent pump.. and when it dies replace w/ something rated for solvent.

Hello, I saw several posts when searching but many of them are old posts.. I'm hoping to maybe find someone with more RECENT experience (year or 2?) in case maybe they have changed the pump they use.. Just picked up one of the cheapo 20 gallon HF parts washers. Picked up a gallon of the...