Recent content by txturf4u

yes this sounds like the easy way but will the epoxy run the color?

Hi Guy's need some help adding some pictures of my floor this weekend to this post, so ya'll will know what I'm starting with. I would like a light gray base with a dual grafic line design with a large C-5 corvette logo in the center. Have the Idea of what I want but no idea on how to do it...

I went with Aluminum also was under 100 an 4X10 sheet from Reliant Steel. Stainless was just too much. Like the cabinets also looking good.

Your thinking right down my line . Painted the frig this weekend and it turned out better than I expected. Used black glossy appliance paint "Epoxy" looks good will post more pictures soon putting texture on the ceiling and doing the floor soon. :beer:

What a starting point and the lift! you can do anything you have lots of room. Looks like you almost have it full too! put a car on the lift and open a bar!

used a 2" 90 degree die grinder with auto body pads and just took off the spurs really fine grinding. The hard part was the table saw. Found that a fine cut cabinet blade worked best and didn't curl the alumi. and left a clean cut. Didn't paint the inside of the cabinets still have the fire...

Love the Matt in front of the frig where can I get one?

Jack see you tiled your garage was thinking of that but was worried about cost and if it was durable enough.

Thanks, just some new black paint and a lot of time on the table saw with the diamond plate

IT all started on accident the local fire dept renovated their kitchen and I ended up with 23 oak cabinets for $200 what a deal. I've spent $400 on metal sheets and paint $200 on wood and a door. Next project is the floor with 2 part epoxy est cost $200 and last but not least a Little flat...

New to this, have watched a little to much DIY channel and started the garage by a cleaning that took 4 weeks. In San Antono Texas.