Recent content by tyrell2004

I stumbled across this video. Thought this technique might be helpful for guys doing new floors who wanted to embed anchors for lifts etc. Seems to allow for slight adjustments of anchor locations to allow for "doh's" Not exactly sure what inside the tubes, (see Video) but more research and...

1977 pumped gas at union76 and we checked under the hood and did windows and aired up tires. "ding ding"

looks great!

you mean Chicago Electric tools from HF are not made in Chicago?? my world view has been shattered........ but, seroiusly I always thought Pittsburgh made in China/Taiwan.

The answer is to play with both of your nuts before you go to see the smokin ********* at the hardware store, even if your bolt is too big.........

Try some oil aborbing pads, like they use in marine and other applications instead of or in addition to the foam. http://www.northerntool.com/shop/tools/product_200045674_200045674

From Page 13 of the manual. Shows the foot guards and the Extension Holder that goes on the base plate, not the arms.

You might have to modify / lower the shut off switch/trip bar, if so equipped, so that you don't run the roof of your car into the ceiling. And you have the trade off of a clear floor (permanent plus) vs. celing mods(one time negative) maintenence/inspection periodic negative as far as access...

I grabbed these images from the manual for XPR-10 Series posted on their website.

I had a Country Flame EPA Phase II firplace insert in Mammoth Ca. @ 1994. Would burn about 4 cords a season of dried pine. I would get a permit for about $8 a cord and go out into the forest in Sept and load up a HF trailer, then bring it hoime and split it. And then have to get it up to the...

Thank you Lord for saving this fine man for his family and letting us all learn again the lesson of how precious life is. Amen. and WOW! God must have some big plans for you and your family! Glad to hear it and we all have learned and been reminded of things we should not take for granted...

There's video here but not sure if it matches your model exactly. Good luck! http://www.northshorecommercialdoor.com/lichwhdr12hp.html

Try this instead ........... Just kidding, no experience with it but the attachments look more interesting that the side lifting, that look kinda scary.......

When I was unemployed for a time, I looked into getting work at Closet World and companies like that for the same reason. A lot of them do garage/ shop systems. I had lots of experience with storage and thought designing and installing garage systems and the like would be fun. But I never got...

I thought most paint desks in big boxes and full service paint stores can sample the color and then color match it these days.