Recent content by VC455

  1. V

    Tube bending: How to correct and overbend in Steel stubing.

    Just a thought, is that going to mess up the AirBag timing ...in the unlikely event it is needed?
  2. V

    need advice on caster operation

    No functional worries minor Aesthetics The Caster effect will just steer a little quicker, take a look at a shopping cart next time you go grocery shopping
  3. V

    Milton 761 1/4" FNPT HIGHFLOWPRO V-Style connectors - (10) for $1.48 (Amazon)

    yup, thanks @jdm5, just bought, via Buy Now, with Free Shipping, be here tomorrow.
  4. V

    Is this Saker grease gun coupler any good?

    I am also intrigued by the advert. There has got to be some Subject Matter Experts on here, anxious to hear your comments.
  5. V

    66 Chrysler steering wheel splines

    Wonderful that you were able to help, and (kinda makes sense. I am not the OP with the issue, I'm just cotinuing my education i. These things. The Reply says 'keyed and will only go on one way [there is one double width spline]'. Then, how does it go on halfway? Halfway double spline??
  6. V

    Mobil 1 FS euro 5W-40 @ $14.80/jug

    Can anyone comment on what "European Car Formula" means?
  7. V

    Ultimate dead car mover

    Smart, very smart.
  8. V

    Need opinions on reattaching a pressed in thermactor air tube

    Yep, this (quote above - smart ) also, The Thermactor air tube, is a non-critical, thermo reaction signal, the ECU will make up little differences, even if proximity bracketed in place. If it were me/my vehicle, I might also JBWeld the joint after the @gmcgeo suggestion. I'd expect to be called...
  9. V

    Internal npt thread repair

    Yep, heat cycles, pressure cycles, vibration, dissimilar materials, 'One & Done, next'
  10. V

    Internal npt thread repair

    Yep JB Weld. I've done the same with 3/4 - 1" high-pressure hydraulic fittings, years with no follow-up issues.
  11. V

    Harbor Freight Black Friday Ad 2021

    yep, also not in one in over a year, I am humbled by admitting I was a "Free" *****, I ofter went in just to get the Free thing, then didn't even bother, just bought something and left, no need for another XYZ (flashlight- whatever.
  12. V

    I saw this in a post on FB...

    Looks like 3 batteries, one upfront and 2 more in the center spine. Quiet and low maintenance.
  13. V

    The repurposing thread

    I have two exactly like the one pictured, One for welding cart the other for air tools/rire repair stuff. Notable features of this particular model is that it is properly weighted at the we bottom, it doesn't tip whenever drawer opened.
  14. V

    Spool tensioner nut is backing off....

    I like this a lot, thanks.
Top Bottom