Recent content by Vehical13

I went to Kenny-u-pull to get body mounts for a 2002 Tahoe. They don't allow me to use a jack. Any Ideas how to leaver the body up 3" to pull the mounts?

Thanks for the tip. H&P Technologies, Inc., has acquired the APCO Pump Lines Business and their website is not user friendly.

When air is compressed it heats up. When its in the tank it begins to cool down and condensation, that's why tanks have a valve on the bottom. If I can cool the compressed air down, with a cooler, then after the cooler and before the tank I'll put water traps. Then the ambient temp in the tank...

I want to put an after cooler between my compressor and the tank. the tank is drilled and tapped (inlet and outlet) for 3/4" The compressor is also drilled and tapped 3/4". For some reason the60 gallon Kobalt 2 stage 175 psi reduced the line to 1/2". First: can I upsize the line to 3/4"...

I recently bought a Kobalt 60-Gallon Two Stage Corded Electric Vertical Air Compressor. Item #905520Model #XC602000 The compressor head and the tank are both drilled and tapped for 3/4" but have brass reducers to 1/2" pipe. What advantage is 1/2" over 3/4" pipe? The outlet hole is also drilled...

I'm up in Maine and am working on a 30x30x27 high gambrel garage. My contractor only used 2x6 trusses and R30 needed 2x8 construction. I ripped a 4x8x1 foam board into 1x1 strips, then glued them to the roof sheathing. By the way this is a cathedral ceiling. Each 2ft bay had the 1x1 strips down...

my garage is 30x30x27 tall. Why do people put seams in board and batton?

I have a 30'x30' Garage with an 8' high x 9' wide for my wife's car. A 10'x10' door for my truck. My bay also has a 10 ton Bendpac AS lift. The lift is within 6" of the truss. The doors aren't centered on each side. The big door rolls up very close to the trusses and the framed out area, near...