Recent content by Viz

Thank you, however Ingram’s had them and they kindly sent my way. Appreciate your response

Yup. I have those pages but would still like to have the templates to work with.

I'm in Florida. Would gladly pay for shipping.

For construction reasons best left unsaid, I'm trying to get my hands on 2 cardboard templates, for the air handlers listed in the Subject line. Multiple calls to MRCOOL were useless, on hold for 30+ minutes every time, no one ever picks up. (I hope that's not an indication of how warranty...

Sent you a private message

Yes, that is the correct, original color. I've had the same model I bought new in 1974. As an aside, does anyone know of a belt guard from other Sears compressors that will fit this compressor with few to no modifications ? No guard was available for this back then. Viz

I’ve had one for several years and have no complaints. A definite PASS

I was just given a Clarke Weld No Gas Mig 95, it's ancient, I know, but visually at least, looks good. I know these, as many small welders do, have some serious limitations, and I am willing to at least experiment with it, just for the limited experience. However, I cannot find anywhere...

The small switch under the sliding fuel selector plate is prone to breaking. About $5. Get a couple

Here ya go…..

Just a heads up. Most of the Champion Dual Fuel generators, including the 100165, plus many others (you will have to check your Parts list), use a micro switch, Champion part # 5.1050.000. This switch is activated by a thin metal "clip" that is depressed by the Yellow sliding cover that is...

Resurrecting thread to ask, is there any one Race Deck pattern that makes rolling the dollies easier ? Circle vs diamond etc ?

Makes sense, thanks !!!!

Ahh, of course!! Thanks !

Rubber garden hose. Male fitting was a standard hose end that had worn threads and wouldn’t retain any attachments/ nozzles. ID is 1/2”