Recent content by volaredon

Ok I replaced the 3 wire plug in the extension cord and realized that I only have a 3 wire plug on the male end. But I have a bare wire (ground) cut back short.... I put a 4 wire plug on the oven so right now only the black and red off the stove are doing anything. I plugged it in and everything...

That's why I fought and struggled to put the pix up... Something that definitely isn't a strong point for me on any website im on

Well you see how far the run would have... So I guess it won't be a huge deal to fix if I didn't already when I wired it 20 years ago.

How does 2,220v circuits automatically mean "no neutral". I have (2) seperate 40a double pole breakers, one wired to each plug. One for the compressor and the other one I plug the welder to. Its been a while since I had the cover off of the breaker box so I can't remember details. I think the...

Mine stays hung on my 75/25 tank which is chained to the MiG

Yup. A couple of feet from my 220 outlets.

I did wind up going and buying a 4 pin outlet for my cord end and a 4 prong plug. . I haven't put them in yet

There is some kind of paper affixed to the side of the oven but I can't see it without either cutting the side of the Wood cabinet out or pulling the oven out of it... Not saying that would be the diagram or not just that that's all I got that might be. I don't see any model or serial number on...

Just wanted to use what I have on hand is all

I have 2, 220v circuits in my detached garage. I have a compressor a welder and a 2 post lift that run off of 220. I have the lift tied into the welder breaker as I am never using both simultaneously but often the compressor is running while I'm putting something up on the lift. Anyway I have...

I haven't read the whole thing but I have had the opposite happen in my 2 latest painting projects... Both done with my air compressor and an HVLP gun. The first time I have ever used an HVLP I'm used to binks and devilibiss siphon feed quart capacity guns. My last 2 projects have taken much...

Finally had good weather and no wind. I filled some dents in the overhead doors and primed them before I painted. The whole reason for going to this amount of work is because after our recent hailstorm state farm will only allow for replacing 3 panels of the 10 that there are between the 2...

Very close. Same style blade clamp as I need. I have one like the linked one as well, this one that needs a blade clamp is shorter and wider And says "sears best" on it. I'll have to dig it out to see if the numbers are still there

Since I last posted I've gained 4 more lanterns. Id like to sell off / trade at least a few of my stoves though. I want another 426 3 burner.

Ok I went to Sherwin Williams as I need to spray 2 of my overhead garage doors. All over Google they show that Sherwin Williams and behr have the paint codes for their factory colors. I actually have the code from Ideal door/clopay and nobody here could do anything with that. The SW "guru"...