Recent content by Walter

Read this thread from the beginning "thegarageguy". All of these points were discussed at length. What is your purpose for this last post? The wording you chose is negative and condescending. You are just another vendor trying to sell his warez. Vulture!

I used it on both. The barn floor is smooth troweled and the apron is broomed. It did well on both. I think you'll need to do some of your own reasearch to see if it blocks moisture from under the concrete. I thought I read something about that but I'm not sure.

Well good. After applying the concrete densifier I am confident that concrete dust will not be tracked into my home or inhaled by children. I am relieved!! Think of the money we have saved instead of using more expensive alternatives. The next thing we need to do is list our lessons learned in...

No, I wasn't being facetious. I had my own problems when I did mine. I used the black buffing pads. Though tougher, using the buffer with the black pad was still difficult to operate until after the product dried. Scott used the white pad which is a less coarse and lighter weight. On...

I'm glad it went well. I am curious as to why you followed the instructions for Ashford Formula instead of the instructions for Diamond Hard.

Hey, I like this Kreg-Jig! I've been planning to make some cabinets and a workbench for the new garage. I see you are from Wausaw. Do you remember that commercial a few years ago? "That's, W-A-U-S-A-U. War-Soar."

I would not use water to remove the excess. I would sweep it off. I don't think it will hurt the grass. Have you read the "Directions for Use" yet?

But she sounds soooooooo hot on the phone. But really folks... It sounds like you just recieved some excellent customer support and that is GREAT!!!

Thanks Chris, I do feel sooooooo Hot today. Grrrrrrrrrrrrrrrrrrrrr

No, it was an every day variety garden sprayer. I think I had a 3 gal but 2 gal will be better than a 1 gallon sprayer.

Yeah get a Home Depot sprayer for 30 bucks. I had no problems with it being caustic or fumes or anything. Just don't drink it. Thank you. This project exceeded all my expectations, including the cost, but it is a most excellent garage. Once again, I will try to post some pics soon. There is...

No problem. I also applied it to the apron which has a broom finish and it soaked right in without a problem. You'll probably see the lines where you applied it but the lines will go away in a couple of weeks.

Scott, The pail thing might work but I really don't have any experience doing it that way. Yeah, I think the sprayer would be best. Make sure you attach the wand so it will be easier on your back. (I just found the wand in the box earlier this week. 2 weeks after I sprayed it on.) I can't...

It looks fine.

Well, good Scott. I think if you spray on a bit heavy and do not use the buffer to work it in it will look fine and do it's job. Then buff it afterward. Mine looks fine. I was over-analyzing everything I did. This isn't rocket science. I've not had a single comment on my floor asking about...