Recent content by wcp0611

Bizzump

I'm cleaning out my shop. All items are new in box. All prices are obo. Hurst 316-2020 Quarter Stick Pistol Grip shifter setup - 375.00 shipped Hurst 316-2001 Quarter Stick Pistol Grip shifter setup - 375.00 shipped Standard IP20 Cummins 5.9V injection pump (don't have a pic of the...

All sold.

I'm converting our attic space over our ranch home to living space in the coming weeks. Its not too much work besides adding more joists and subflooring it all. In years prior, we did a few remodels where some rewiring had to be done in the attic from room to room. This caused a bunch of...

So, back to my first post, if I put the 100amp breaker for the shop in the left panel that feeds the house as well, could I backfeed power from the generator at the shop to the house panel? To clarify, I'm not looking for power at the shop if the lines are down. I'm just looking for power to...

The arrows in the diagram were just to help show the distance. They weren't electrical direction.

Welp, I'm a liar. Went out and checked and I did run a a four wire to the shop. It's been seven years. I forgot.

Haha absolutely not!

Well, codes pass me on it. I ran two ground rods at the sub at the shop and the house already had two ground rods.

The triplex was ran maybe seven years ago. Why?

Okay, let's say I add an interlock to both main disconnects at my house. Does this work then? I'm okay with criticism. Lord knows I'm not an electrician.

Can someone take a look at my little doodles and tell me if any of this is a possible code violation? Right now, my shop is fed off of 1/0 URD triplex coming from a 100amp breaker at my house. Its a little over 160ft away. I have been wanting to add a diesel generator for backup power for...

I did this too. Anywhere feeder was going through a stud has two on top of each other. Small price for the big insurance.

I white caulked it last night. It was so close to the edge that I just caulked it all the way to the bottom plate of the walls so the inspector can't fail me for not caulking that seam.

There is a 1/4 gap between the original subfloor and the additions subflooring due to working around a few wires I couldn't get removed when they stared building the addition. The wires are removed now but I need to seal it up. Its a run of about 1/4" x 27'. Would you use caulk or spray foam...