welder4956's latest activity
-
Wwelder4956 replied to the thread Running 250psi- what piping system?.I agree with those recommending Type K or L copper pipe with silver solder. The downside of schedule 40 carbon steel is that threaded...
-
Wwelder4956 replied to the thread Running 250psi- what piping system?.All the ones I welded for TDU or ejection air were 304 stainless. But that was hull numbers older than 672. Although I can see where...
-
WMy vote is toilet and shower only in the WC and sink on the shop side of the wall and an outswing door.
-
WNix shower, put sink across from toilet, rotate so door hits side of sink. Could do a "shower" by making the whole floor a drain pan...
-
Wwelder4956 replied to the thread Safe to install an angle grinder cut off wheel on a bench grinder?.OP needs an angle grinder bench stand to hold the grinder steady. Don't miss an opportunity to buy a new tool! Or make your own and bolt...
-
-
Wwelder4956 reacted to bmwrd0's post in the thread What did you do "IN" your garage today? with
Like.
Scrapped more paint off of the lathe, filed more on the extractor. Also started the semi-weekly shop declutter process. -
Wwelder4956 reacted to NWOhioChevyGuy's post in the thread What did you do "IN" your garage today? with Like.
Serviced the generator & mower. Long overdue oil change on generator, plugs & air filter. Getting it ready to put on a skid with an...
-
Wwelder4956 reacted to Outlawmws's post in the thread What did you do "IN" your garage today? with Like.
Did a clean and Lube on my other 1/4" SO GM 70 S and the GM 70 M as well yesterday
-
Wwelder4956 reacted to Hooked's post in the thread What did you do "IN" your garage today? with Like.
Got out in the workshop for a short while Saturday after a 2 week 'break' due to severe case of gout in an ankle. Power window on...
-
Wwelder4956 reacted to Mezz2006's post in the thread What did you do "IN" your garage today? with Like.
Prepped and painted the interior of one of the garage entry doors. I had done the outside previously, so this leaves only the house to...
-
Wwelder4956 reacted to TRWham's post in the thread What did you do "IN" your garage today? with Like.
Cylinders, pistons and cylinder head installed. Took Saturday “off” to help our youngest move.
-
Wwelder4956 reacted to pancholasvegas's post in the thread What did you do "IN" your garage today? with Like.
Alright boys - this is the end of the line. Loaded up the box into the trailer and pushed it out. Next time it’s back here, it’ll be...
-
Wwelder4956 reacted to pancholasvegas's post in the thread What did you do "IN" your garage today? with Like.
Alright gents, we’ve been doing this a while and we’re through with our obligation. These past few weekends and finally this weekend...
