Recent content by whitemamba

I ordered the honeywell for 50 on ebay, seems basic enough and it gets to 40 for heat, i just dont need 50 and above if im doing real work in shop

searched through a lot of old post and couldn't find anything recent on wifi thermostats for these installs? Figured technology changes so fast the stuff from 2015 isnt too relevant. Not so concerned with keeping shop above a certain temperature simply want to be able and turn on and set before...

I ordered a hot dawg. The jump from 1500 cfm to over 1900 for about a 100 seemed worth it, now to find a wifi thermostat for it and get new gas line teed off from gas company

36x84 pole building 1 1/2" closed cell foam on walls and 3" condensation control blanket on roof, commercial uninsulated doors 3 10x 12 and 2 12x14 figuring 125k , both seem comparable in price but hot dawg puts out quite a few more cfm. Thoughts?

9 left at Home Depot in downtown Seattle, there were 10 but I bought one.

Newage customer service was great, sent me out 2 shock packs for my cabinets.

Ran out, Amazon will have me another set Tuesday. Got a bunch of small pieces I will try and do something with.

Yes, but I will still need some regardless of warranty. See what they say when they get back to me. Thanks again.

Been sitting on these over a year, finally got them up yesterday, everything was packed nice and looked great! I’ve got two uppers that the shocks seem defective so I’ve sent newage a email to see if they will take care of it. The salt wall I don’t think was out when I ordered so I using wall...

I used the green light depot lights, Eve height is 16’ they hanging off trusses at 14’7”

you ever get parts for this or toss it? I have one that is a BT55C/Dayton and have a busted pulley. I got ahold of meiji and even though its still in their catalog they claimed they never exported it and then I sent them a picture and then they said it was too old for parts... nevermind I see...

Doing install in my 36x84 building doing outlets and need to go to lifts, any ideas besides so many tee’s at $20 a piece. 3/4 max line. I bit the bullet and bought a 5 pack of tee’s

I'm about to install 2 kits but think i will end up with a third due to extra fitting costs. There are not enough Tee's in master kit and no tee's to reduce so for a hose reel install you have to either go tee and a end with male before jumper hose or find the 3/4tee to 1/2 which isn't available...

Just finished, these are the 110w fixtures from green light depot. Building is 36x84 16’ eve height and bottom of lights is 14’ 2”. Seems to be plenty of light, I do have extra row at work end that I’ll have tomorrow and it should be incredibly bright there.

I ordered my lights like 6 months ago and am just finally got to installation.