Recent content by WIKDRacing

Their customer service is probably one of the best I have seen and dealt with. They want to make sure you are completely satisfied with the purchase and equipment. You can get it cheaper on their website over amazon.

I bought a brand new Mayflower Tire Changer with assist arm and balancer for a great price. So far I have only had one issue, bowl of regulator had a small crack causing a leak. Mayflower immediately shipped out a new one. I have changed 6 sets of tires so far, including run flats and it has...

I am having the same problem with a Senville unit leaking on the inside. It has leaked so much that I have now had to pull the cabinet down that was below it and tear drywall out due to a large mold area. I am about to pull the rest of the cabinets down, removal all the drywall/insulation from...

WIKD Racing 40x60 Shop Build https://r.tapatalk.com/shareLink?share_fid=20318&share_tid=372193&url=https%3A%2F%2Fwww%2Egaragejournal%2Ecom%2Fforum%2Fshowthread%2Ephp%3Ft%3D372193&share_type=t I have a few pics of my compressor closet at the bottom of my thread. Very similar to YouTube video...

Good review. I've had this generator on my car trailer for almost two years now. I love it.

The door has a larger than normal gap at the bottom. I cut a little off. I wanted to see how that works before putting a larger vent to the side of the door. I do have a pretty stout exhaust fan that pulls air in and vents it out the wall. So far hasn’t been a big issue. Compressor stays...

It has been a long time since I posted an update. The shop is coming along. I built a compressor closet underneath the stairs to quite down my new Bel-Aire 60 gallon compressor and installed a Max Air kit to one of the major places I need air. Still need one more 150ft kit to get to the other...

Awesome, I have the same press. My only complaint is with the longer press shaft there is not enough room to press off/on axle bearings. Nothing a little trimming can’t fix. Looking forward to updates on bumper. Sent from my iPhone using Tapatalk

I have a Danmar D-10ACX and lift my F-350 regularly for oil and fuel filter changes.

I ran mine outside only because it was up against the outside wall. I also went with 1/2" black iron pipe to the manual valve, then to the automatic valve that's on an additional timer to a small run of 1/2" PEX :wtf: out the wall.

Looks great. I will be doing similar in my shop for the walls. I am just waiting to make sure I have everything electrically I want in place before closing up the areas.

Welcome Mitch. I just ordered a 3/4" Maxline system today for my shop. Will be doing the install this weekend, I hope.

Nice. I have a similar set up in my 40x60 as I wanted to squeeze as much power out of the electric company as they would allow the first time. I have 200amp panels, one on each side of the shop with a main 200amp disconnect feeding the second from the commercial meter box on the exterior.

Oh glad I picked one up last year then. I was looking for one for a friend a couple months ago and couldn’t find it. Now I know why.

Thank you for the responses. Good to see for a small shop consensus would be 1/2" lines. It is not a large space, only 40x60 but with a room framed out in the interior as well. I believe from the start I will only have air drops to half of the shop with capability to expand where the dyno...