WildBill's latest activity

TPU vise jaw covers

I had the exact same issue on my shop and used a cheap harbor freight hot knife to cut the top 8" inches or so of foam down where needed...

Depending on what you are hanging these spring steel (I think) ones that just make a tiny hole work great. I've hung 25-40 pound signs...

It's a pressurized can of dry inert gas designed for purging lines during installation but you can use to try and find leaks if you...

You could potentially buy one of these purge kits to test for leaks, I've seen them as cheap as $30...

These are by far the best ones I've tried. No sweaty hands so they go on and off easy, and as stated can be used a couple times. Also...

I have been using Nickelbacks for a couple of years and they work great for me. Easy to get on and off, and no problem with sweating. I...

I did 6" for my shop. Figured I would be sure to get at least 5" everywhere by calling out 6". Actually ended up more like 6-7"...

Guy that I hired to mud/tape when I built my house didn't sand anything and it was perfect. He just used a broom to brush off the...