Recent content by windex23

Doing the uploads of the images and all my posts directly from the Tapatalk app, on my phone, that might explain it, sorry! I'll try your recommendations next time I'm on a computer, which is not too often aside from on the job. Envoyé de mon Pixel XL en utilisant Tapatalk

Painted the welding table today, as well as fabricating a lower shelf for the welder and the chop saw: I need some 4 in flat bar for the cross section of the shelf, and shorter 5/16 bolts for finishing though.

Thanks for the comment! The way the house's land is does not allow for this kind of structure, especially because the neighbors on each side are too close to fit in a new structure. We still have two driveways, which is sort of rare, and the one not in front of the garage allows two cars to...

Water used to get into the garage, but I did a few modifications to fix this: Changed the sump at the bottom of the garage paved way for a trench sump, I also changed the rubber seal under the garage door and poured sealing concrete in a few spots where the slab was uneven. Now, water almost...

And more recently, I added a 5000w 240v heating unit on the ceiling because with the actual outside temperature around here (-25C/near -13F) it became way too cold to rely only on the heat from the rest of the basement to heat the garage through the door. Future projects include finishing the...

I also changed my International 42in tool chest for a 57in Husky chest. I fabed a little welding table as well as a workbench out of industrial racking supplies. The welding table frame is 24 x 30, the top being 3 in wider on each side, making it a 30x36 table. The workbench is 24x72 inches...

Lighting job continued with more two H8 neon tubes units. At the moment, 5 of them are at the ceiling. A 6th one is temporarily installed near the garage door, awaiting for two more units the be wired on the electrical circuit. Soon after, walls got painted with a concrete white primer. I...

Then, at the end of last summer, I bought one of my dream cars: an Audi RS4 B7 colored in Misano red. It became obvious the garage needed more lightning and to repaint the walls at some point. I could not stand the awfull purple walls anymore with the RS4 being in the garage am the time. I...

Then, last winter, I started welding for fun on my trail XJ Cherokee a steel bumper and took a real kick in welding, so much that it was more one plans to get a real welder ( better than my 120v flux core I have at the moment) and a welding table.

First modification, as stated previously, were the hot water, metal cabinets, placing the stuff in order to be able to fit a car in, install wall storage for plastic bins, as well as dismantle the wooden rack the previous owners used to store stuff:

Hi to all fellow members, long time lurker of the GJ forum for a while now, time to show off my own space now! Disclaimer: I did the whole thread on my phone, some pictures might show up twice. Disclaimer #2 : English isn't my mother tongue, I speak French at home. Few sentences might be...