Recent content by WKDiesel

I actually used brake cleaner on a rag and it seems to clear it up a little. My entire floor ended dulling so it's not as noticable anymore. My experience with epoxy floor was not as good as I thought it would be. I think I'll just be going to a polished floor with a acrylic sealent in the...

It's an UV stabilized EPOXY top-coat they put on. It's not yellowing just dulling. I might just have to flood the entire floor with water just to get a uniform look now.

I tried acetone. It doesn't do anything. I'm able to scratch the dullness out with my finger nail. But it takes a long time and alot of pressure. It's happening over the entire floor once exposed to water. Which seems like an issue withe product? I was thinking of just hosing down...

I tried a hair dryer / heat gun and heat doesn't give back the original gloss. It definitely looks the dullness is on the surface.

Dull / Chalky Section Normal Section If it's a moisture issue will it weaken the epoxy?

Could the water marks be yellowing / chalking? I was reading H20 could accelerate the processs.

PurEpoxy PE-100 was the top cote. It was suppose to be 100% Solid Clear Epoxy. The floor seems dull after getting wet. This is the actually the first time the floor has gotten wet since it was installed. I use my garage as my home office and hobby space and not actually parking cars. My...

This seems to happen anywhere on the floor that is exposed to water. I tried with tap water and I get the same dulling after the water dries.

Help - Stains on Epoxy Floor? I've gotten some water on my epoxy floors by the entry doors. I didn't wipe it up and it dried naturally. Now the epoxy coating is cloudy / dull where it the water dried naturally. Is this a defect in the product, how would I fix? Floor was installed in...

Did costco.ca (Canada) stop carrying the Pro 3.0 Line?

The contractor used a brand called Purepoxy. 100% solids.

I ended up finding a company that diamond grinded the floor prior to installation

I just completed my Garage. After pulling up the ram board I'm not to happy with the way the power trolled floor turned out. Too many swirls and there are some lines / curing mark where the tape was. Now I'm looking at epoxying the floor. A had a company that came out, which was...