Recent content by woodstockva

It looks angled since you tightened the nuts prior to clamping the clamps onto the stand......you need to loosen each nut, unclamp them, align the clamps evenly (move the front/back left to right), clamp them tight & then tighten the nuts. I have used that stand with numerous miter saws & had...

To move mine, I unbolted the motor & pump......and moved the tank by itself, then put the pump and motor back on once it was in the garage.

I have one.....and a review coming out shortly on it. Pros - Aluminum tanks, VERY quiet, low amp-draw, 2 outlets, 3yr warranty Cons - 120psi max, Aluminum tanks (not as strong as steel.....can get dented/damaged much easier) It airs up pretty quickly & I can run ANY nailer at the end of a...

I saw that one in-store the last time they had them in (prior to BF & also at the same exact $49).....the reel is very lightweight & flimsy compared to a normal reel. DIY/Homeowner occasional use would be "ok", but not for any long-term consistent use.

Home Depot by far has the best tool deals this year!

I have done two videos on them if you want to check out some specific models/brands against each other... <iframe width="560" height="315" src="https://www.youtube.com/embed/QCoFh8K1Cb0" frameborder="0" allowfullscreen></iframe> <iframe width="560" height="315"...

Most likely not enough air pressure.... <iframe width="560" height="315" src="https://www.youtube.com/embed/MHx2EUWYzuM" frameborder="0" allowfullscreen></iframe>

Every single manufacturer experiences manufacturing defects....even Snap-on. The ironic thing is that out of the thousands of people who are satisified with their SK tools, the very few who decide to make GJ posts about "poor quality" seem to sway public opinion about the overall quality of...

I like signs, garage art, toolbox stickers, and XL T-shirts. :)

Hey Everybody - In response to a LOT of comments & messages after the last video (SK vs Snap on vs WrightGRIP) asking about the strength of the box end & specifically "would it shear the head off of the grade 8 bolt, or would it fail).....I decided to make a video to find out. Check it...

I'm in! :)

Hey everybody - Now that SK is finally shipping the new X-frame wrenches, I got the SAE set in & decided to see how the open end would perform compared to the WrightGRIP & Flank Drive+. As we all know from previous testing, almost all wrenches fail (deform and/or round off corners) where the...

The SWAG table works very well.....and the various models of it are already designed to work with most of the major models of portabands. I would highly suggest a corded model + aftermarket on/off footswitch --- instead of a cordless model (for stationary use). Here is a video that I made...

Bingo! ;) I would say that the majority (especially power tools) are primarily made in China, Taiwan, etc.....with the exceptions being USA, Canada, Germany, Japan, etc. Since people seem to like North American & European tools a lot, I do point that out (when I know about it). That being...

I made a review about them... <iframe width="560" height="315" src="https://www.youtube.com/embed/Yikg5cQ_mYw" frameborder="0" allowfullscreen></iframe>