Recent content by WTP07

Finally have her all set up, now that the sound system is installed. :deathmeta I have some bike (FJR) upgrades scheduled and my buddy will be working on that 68 'stang all winter too. It's good to be back! :beer:

An air dryer of some sort is a must. Blasting uses a lot of air, and when the compressor is running constantly, it creates a lot of condensation. Without an air dryer you will be constantly clearing the gun. A dessicant type dryer will work for your application here.

This also concerned me, but I have torches as well. Sounds like I am going to leave it alone and just run my lines from the bushing. PS, nice shop cow. I have one of those too.

Ok, thanks! I appreciate it! :)

I was planning on 3/4" lines with 3/4"x 1/2" TEEs for the QD outlets.

I was more worried about volume loss for things like die grinders and air sanders. Am I wrong in my thinking that smaller pipe diameter = less volume? I guess everything comes through quick disconnects which are pretty small...

Hey all, Finally got my shop set up again after my divorce. I'm located in Strathroy, just west of London. 26x26 fully insulated, brand new build. I'm pretty stoked. I'll post some pics when my post count gets high enough. Still getting things set up, but it's nice to be out of the...

Hey all, I have had this compressor (Sanborn from Princess Auto) for a couple of years now and finally just got it into my new shop. I'm starting to run airlines and realized that PA/Sanborn put a 2"x 3/8" bushing in the tank. I want to replace it with a 2" x 3/4" bushing but I cannot find...